v class="col-md-6 padding-r" style="box-sizing: border-box; float: left; font-family: 'open Sans'; font-size: 13px; min-height: 1px; padding-left: 15px; padding-right: 0px !important; position: relative; width: 569px;">

Design A Power Electronic System Teacher Required In Nnnn-Online

View Contact Details

• Phone xxxxxxxx26
• Email xxxxxxxx@tutors99.com
• WhatsApp xxxxxxxx26
• Area Australia online
• Address
• Status Opened

Tutor Needed With Requirements

Subject (B.Tech/B.E.) Electrical engineering

Priority Immediately

Budget Rs 1200 Hourly

 

Tutor Type Online Tutor

Budget Type Hourly

Duration Needed 6 Months

Requirement Details

Details: Design the circuit design a power electronic system, referred to as ‘the device’ in below, which has the following specifications: - The device is supplied from a single-phase wall outlet which has a 240 V rms, 50 Hz specification (through terminals I1, I2). - The device can generate a fixed 5 V dc (through terminals O1, O2, O3). - The device can also produce a variable 0 to 20 V dc (through terminals O4, O5). - The device can also produce two fixed 60 V 50 Hz ac outputs, that can even be connected in series to produce a fixed 120 V ac (through terminals O6, O7, O8). - The device can also produce a variable 0-60 V, 50 Hz or 60 Hz ac output (through terminals O9, O10). There will be a up/down button on the device to select either 50 or 60 Hz. - The device will only have one of its outputs functioning at a time (i.e., it will not be loaded through multiple outputs simultaneously). - The device should be able to supply a load (a variable resistor with a minimum resistance of 10